Instructions to run the simulator

Simulator contains 6 steps

• Introduction
• Configuration
• Connection
• Characterization
• Calibration
• Fault Detection

Procedure to run the simulator's 6 steps:

Introduction

• Select the application.
• Read the theory and start the test.
• Attempt all the questions from the test and submit the test.
• Click Next level.

Configuration

• Select transmitter type and do necessary calculation to configure it.
• After Successful configuration click Next Level.

Connection

• According to selected transmitter type, Select the require components from symbol library to do the connections.
• Click check connection button.
• After successful connection click Next Level button.

Characterization

• Take multiple readings to check output of transmitter.
• Plot the graph for the same readings.
• Click Next Level

Calibration

• Calculate zero error, span error, linearity and Average Percentage Accuracy.
• Calibrate the Transmitter.
• Remove zero error
• Remove span error.
• Try to get the linearity.
• Click Next Level

Fault Detection

• Detect the 3 faults for the transmitter’s few reading.